Dedicated Fax Line Setup Guide MX360 or MX410 Next
Connecting The Phone Lines Previous Next
Connecting The Phone Lines Before Wall jack After Wall jack (Phone Cord included with Canon printer) Previous Next 3
If Your Wall Plate Has Two Jacks Use the jack that supports the fax line.
If Your Wall Plate Has One Jack For Two Lines If your wall jack provides one jack for two phone lines, it would be best to use a “2 Line 3 Way Adapter.” This adapter can be purchased at most stores that sell electronics. This device creates three plugs where there was one. One jack will be for your voice line. The other jack can be used for your fax transactions. In most cases, line 1 (L1) is used for phone calls; L2 is used of faxing. The third jack (L1+L2) allows access to both lines.
Fax to Phone Line Connection First, connect one end of the supplied telephone cord to the telephone jack on the wall.
Fax to Phone Line Connection Next, connect the other end of the supplied telephone cord to the lower jack (labeled “L”) on the MX360 or MX410.
Setting Up The Receive Mode Previous Next
Step 1 Step 2 Turn on the MX360 or MX410 by pressing the ON button. Press the FAX button.
Step 3 Step 4 Press the Menu button Use the Left or Right Arrow button to select “Receive mode set”.
Step 5 Step 6 Press the OK button The “Receive mode set” screen will appear Previous Next 11
Step 7 Step 8 Use the Left or Right arrow button to select “Fax only mode” Ensure that “Fax only mode” is displayed Previous Next 12
Step 9 Step 10 Press the OK button The “Make advanced settings?” screen will appear Previous Next 13
Step 11 Step 12 Press the FAX button Your MX360 or MX410 is now set to FAX only mode. Notice that the mode is listed on the fax standby screen.
To Receive A Fax When a call comes in on the fax line, the MX360 or MX410 will answer the call and begin receiving the fax. You do not have to be home or interact with the MX360 or MX410 to receive a fax.