Technical information

IV. SEBTING I-HE CT UNn
3) Put the CT unit back into Ihe sloraae case and
I
1) Hold both ends so that the yellow seal (round) is
tothefront,andturnitinthedirectionofthearrow
about ten times as shown below.
Figure 5-16
2) Take the CT unit from the storage case, and set
it in the copier; thereafter, hold the CT unit in
place, and pull the yellow tab straight out.
Note:
Do not pull out the orange film.
5)
6)
Figure 5-17
COPYRIGNT = 1992 CANON INC.
shake it about ten times in Ihe dlreclion of thc
arrow.
Figure 5-16
Shake it in the direction of the arrows about ten
times.
Figure 5-19
Set the CT unit in the copier once again, and
make test copies in the DIRECT mode; repeat
step 4) if the image is uneven.
Set the CT unit in thecopier, and pull the orange
tab straight out; thereafter, close the front door.
) Tab(orange) 1
Figure 5-20
CANON NPZlZO/ZMO RN.0 MAY 1990 PAINTEil IN JAPAN IIMPRIME AU JAPORI
5-l 3