Technical information

B MECHANICALSYSTEM
3) Slide the grip plate in parallel to the body, and
6) Make copies using the paper deck.
adjust the registration at the front and rear.
7) Repeat steps3) to 6) if the registration is outside
the standards.
8) Fix the front cover so that the gap between the
front cover and pedestal frame is about 0.5 mm.
0.5 mm (approx.)
Decrease the non-image width
a, lhe front; increases he non-
image widh at the rear.
Front cover
Decrease the non-image width
at the rear; increases the non-
image width at tk front.
about 1 mm. l
Figure 3-217
4) Tighten the four mounting screws on the grip
plate after adjustments.
5) Set the deck.
Note:
Slide it to the front thereafter, without releas-
íng the latch.
I
Pedestal frame
3-6P
cOPYRIGHT 0 1992 CANON ING.
CANON NP2l20/2G20 RN.0 MAY 1990 PRINTUI IN JAPAN IIMPRIME AU JAPONI