Technical information

@ Do not process each side more than once; and
@ Do not use both overlay and two-sided copy
modes on a single sheet of paper.
Figure l-5
F, Making Overlay Copies
Byreplacing thedeveloping assembly, thecopymay
carry two colors; keep the following in mind:
0 Check the paper is of 64 to 128 glm’;
Q Do not process each side more than twice; and
@ Do not use both overlay and two-sided copy
modes on a single sheet of paper.
G. Replacing the CT Unit
1) Open the front door.
2) Turn the developing assembly release lever
counterclockwise.
3) Slide out the developing assembly to the front.
4) Hold the grip of the developing assembly, and lift
the assembly slowly.
Figure l-6
5) Place the CT unit on the developing assembly
rail, and slide it in.
6) Turn the developing assembly lever clockwise.
7) Close the front door.
1. GENERAL DESCRIPTION
Note:
1. Donottiltorshakethedevelopingassembly
or CT unit.
2. Do not place the developing assembly or
CT unit on the floor; rather, keep them in
storage boxes.
H. Using the COPY DENSITY
CORRECTION Lever
If the copies are always dark or light, slide the lever
to obtain the desired density.
COPY DENSITY
CORRECTION lev
Figure 1-7 COPY DENSITY
CORRECTION Lever
COPYAIGHT 0 1992 CANON ING.
CANON NPZl20/2MO REV.I OEC. 1592 PAINTED IN JAPAN (IMPAIME AU JAPONI
i-ll