Technical information

@ Adjusting the AE Slope
1) Remove the Test Sheet, place a newspaper on
the copyboard, and close the copyboard cover.
2) Press the SORTIGROUP key on the control
panel.
* The copier operates as in step 5) of “Adjusting
the AE Referente Point.”
3) Take notes of the value shown on the copy
counter of the control panel.
4) Press the SORT/GROUP key on the control
panel.
- The copy counter on the control panel will
indicate ‘0’.
5) Enter ‘1’ on the tenkey pad on the control panel.
- The copy counter on the control panel will
indicate ‘1’.
6) Press the SORTIGROUP key.
7) Turn VR2 (AE slope) on the adjusting PCB so
that the value on the copy counter of the control
panel is the same as the value recorded in step
3)
Document denslty
Test Sheet Newspaper
Figure 3-33
8) Press the SORT/GROUP key after making ad-
justments.
9) Press the push switch (SWI) on the adjusting
PCB
Blank
Figure 3-34 Adjusting PCB
COPYAIGHT @ 1992 CAllON INC. CANON NPZlZO/ZMO RN.0 MAY 1990 PRIHTEO IN JAPAH IIMPAIME AU JAPONI
3-35