Operator`s manual

4-13
Additional Functions
■ Energy Saver Adjustment
In the Energy Saver mode, the temperature of the fixing
unit is lowered to reduce energy consumption. The
amount of energy saved can be changed.
Select ENERGY SAVER ADJUSTMENT.
Select the Energy Saver setting, then press the
[OK] key.
MEMO: ● The default setting is an Energy Saver setting of
–10%.
● If you select –10%, then the copier will consume
10% less energy than normal.
● If you select –25%, then the copier will consume
25% less energy than normal.
● If you select –50%, then the copier will consume
50% less energy than normal.
● If you select RETURN DIRECTLY TO STANDARD
MODE, then the copier will consume 8% less
energy than normal. You can make copies
immediately because when this setting is selected, it
puts the copier in the same condition as when the
copier is ON and “Ready to copy,” appears in the
display.
● The amount of time that it takes before the copier
can return to the “Ready to copy,” condition and you
can make copies once again varies depending on
which Energy Saver setting you have chosen.
The approximate amount of time that it takes for the
Energy Saver settings is as follows:
(The amount of time it takes the copier to return to
the “Ready to copy” condition may vary depending
on environmental conditions.)
–10% mode: Approx. 50sec., –25% mode: Approx.
1min. 40sec.,
–50% mode: Approx. 2min. 50sec.
1
■ Change Standard Copy Settings
The standard copy settings are those copy settings which
the copier returns to after the
Reset
key is pressed. You
can freely change and store the standard copy settings.
You can also restore changed standard copy settings to
the factory-preset (initial) settings.
The factory-preset (initial) standard copy settings are as
follows:
• Copy exposure : Manual Exposure Control
• Paper selection : Auto Paper Selection
• Copy quantity : 1
• Copy ratio : Direct (100%)
• Copying : 1 → 2-sided
Select CHANGE STANDARD COPY SETTINGS
after specifying the mode you want to store as
the standard copy settings.