Operator`s manual

5-5
Loading Paper and
Adding Toner
3
Open a package of copy paper, and remove the
paper stack. (Make sure that the seam on the
center of the package is face up.)
NOTICE: ● Rewrap any remaining paper in its original
package, and store it in a dry place away from
direct sunlight.
● Do not copy on the following types of copy stock;
doing so may cause a paper jam.
• Severely curled or wrinkled paper
• Transparencies for digital full-color copiers
• Paper which has been copied on using a digital
full-color copier (do not copy on the reverse side
either)
• Paper which has been printed on using a
thermal transfer printer (do not copy on the
reverse side either)
MEMO: ● Drawer 3, 4 each holds up to approximately 550
sheets of copy paper (20-lb bond).
● For high-quality copies, use paper recommended by
Canon.
Place the paper stack in the paper drawer.
Even out the edges of the paper stack. Load the
paper stack against the right wall of the paper
drawer or paper deck.
REQUEST:
● Do not place any objects in the empty space of
the drawer, as this may cause damage.
NOTICE: ● If the copy paper is curled, curl it down before
placing it in the paper drawer.
● Make sure that the height of the paper stack does
not exceed the limit mark ( ) at the back of the
paper drawer.
● Make sure that the paper size setting in the paper
drawer matches the size of the paper to be
loaded. (See “Adjusting a Paper Drawer to Hold a
Different Paper Size,” on p. 5-7.)
4
Grip the handle on the front of the paper drawer.
Gently slide the paper drawer back into the
copier until it clicks into place in the closed
position.
CAUTION:
● When closing the paper drawer, be careful not to
get your fingers caught in it, as this may result in
personal injury.
5