Operator`s manual

1-11
Introduction
Select a safe power supply
• Plug the copier into a 120V AC outlet.
• Do not plug other electrical equipment into the
outlet to which the copier is connected.
• Do not plug the copier into a multi-plug power
strip. Doing so might cause a fire.
• The power cord may become damaged if it is
often stepped on or heavy objects are placed
on it. Continued use of a damaged power cord
can lead to an accident.
• Do not remove the copier’s fixing stoppers
after the copier has been installed.
• If you put weight on the front of the copier
while the paper drawers or units within the
copier are pulled out all the way, the copier
might fall forward. To prevent this from
happenning, make sure that the copier’s fixing
stoppers are set in place.
About the copier’s fixing stoppers
Moving the copier
• If you intend to move the copier, contact your
service representative beforehand.
Provide adequate installation space
• Provide enough space on each side of the
copier for unrestricted operation.
50-
3
/
8
"
48-
7
/
8
"
59-
7
/
8
"
48-
7
/
8
"
<Copier equipped with the
optional Stapler Sorter
and the Paper Deck-A1>