Operator`s manual

1-12
• Do not attempt to disassemble or modify the
copier.
• There are some areas inside the copier which
are subject to high voltages and temperatures.
Take adequate precaution when performing
internal inspections. Never perform any
operation not specified in this Operator’s
Manual.
• Be careful not to drop any foreign objects
(e.g., paper clips) inside the copier. Never spill
liquids of any kind on or into the copier. If a
foreign object or liquid should come in contact
with a high voltage area inside the copier, it
could cause a short and result in a fire or
electrical shock.
• If the copier fails to operate normally, see
pp. 7-2 through 7-4. If there is an unusual
noise, smoke or anything which causes
concern, immediately turn the power OFF, and
unplug the copier. Then, call your service
representative. Always allow enough space in
front of the power outlet so that you can easily
unplug the copier.
• Do not turn the power OFF or open the front
door during copying. Doing so may cause a
paper jam.
• To avoid danger of ignition, do not use
flammable aerosol products, such as spray
adhesives, near the copier.
• If the copier will not be used for a prolonged
period of time, such as at night, turn the power
OFF.
• After turning the power OFF, the copier’s fan
will operate for approximately 10 minutes to
enable the copier to cool down.
Handling Precautions