Operator`s manual

2-2
After approximately 5 minutes (at a room
temperature of 68°F), the message to the right
appears in the touch panel display, indicating
that the copier is ready to copy. At this time, the
copier is in the Standard mode and the standard
copy settings are in effect.
MEMO: ● The standard copy settings are as follows:
• Copy ratio: Direct (100%)
• Paper selection:Auto Paper Selection
• Copy exposure: Manual Exposure Control
• Copy quantity: 1
• Copy function: 1→2-sided copy
● You can change the standard copy settings. (See
“Change Standard Copy Settings,” on p. 4-13.)
Turning the Power ON
This section describes how to turn ON the copier and the steps to be followed until “Ready
to copy,” appears in the touch panel display.
Make sure that the power plug is firmly inserted
into a power outlet. (See “Select a safe power
supply,” on pp. 1-3, 1-11.)
WARNING:
● Do not insert or unplug the power plug with wet
hands, as this may result in an electrical shock.
1
Press the power switch to the ON position.
MEMO: ● The power switch is located on the right side of the
main unit.
● To turn the power OFF, press the power switch to
the OFF position.
2
During warm-up, the display at the right appears
in the touch panel display.
MEMO: ● You can program the copy settings for the first copy
job while the copier is warming up. (See “Auto Start,”
on p. 2-27.)