Operator`s manual

2-35
Basic Copying
If the interrupted copy job was being run using the RDF, and you use the SADF tray for interrupt
copying, then you do not need to lift or lower the RDF to remove an original from the platen glass.
When Placing an Original in the SADF Tray of the RDF
Press the
Interrupt
key.
The
Interrupt
key begins flashing.
1
After the current copy job has stopped, the
Interrupt
key lights continuously. The message to the
right appears in the touch panel display,
indicating that you can begin copying.
MEMO: ● When the copier is programmed to Auto Start, you
cannot use the Interrupt mode.
● If an ID number was being used to run the current
copy job, then, after the
Interrupt
key is pressed the ID
number entry screen is displayed and an ID number
must be entered in order to make interrupt copies.
(See “Entering an Access-control ID Number,” on
p. 2-38.)
Open the SADF tray of the RDF.
MEMO: ● If the interrupted copy job was being run using the
platen glass, temporarily remove the original from
the platen glass.
2
Program the necessary copy settings.
MEMO: ● You can enter up to 999 copies.
3
Clear
Guide
Additional Functions
Interrupt
Reset
Clear
Energy Saver
Stop
Guide
Additional Functions
Interrupt
Start
Display Contrast