Operator`s manual

2-38
If the ID mode is set on your copier, it is necessary to enter a six-digit ID number after
turning the power ON. If an ID number is not entered, the copier cannot be operated. The
following procedure describes how to enter an ID number.
Entering an Access-control ID Number
Entering an ID Number After Turning the Power ON
Press the power switch to the ON position to
turn the power ON.
MEMO: ● If your copier is equipped with the Control Card,
“Insert a control card” will appear in the touch panel
display after turning the power ON. Insert a Control
Card. (See p. 8-22.)
If the message to the right appears in the touch
panel display, copies cannot be made until an
ID number is entered. Follow the procedure
described below to enter an ID number.
Enter a valid ID number with the Number keys
(
1
–
0
).
If you make a mistake during entry, press the
C
Clear
key and enter the ID number again.
1