Operator`s manual

2-42

The Fit Image mode enables you to reduce the size of the original slightly so that no parts of

the image are cut off on copies, even if the original image covers the entire page.

MEMO:

● You cannot set the Fit Image mode together with the Zoom, or Zoom Program and Margin

modes. The Fit Image mode can be used with only the Margin mode if Center Shift in the

Additional Functions is set to “OFF”. (See “Additional Functions/Fit Image Adjustments,” on

p. 4-12.)

Fit Image Mode (Slightly Reduces the Size of Originals)

Place your originals.

■ For instructions on how to place an original on

the platen glass, see p. 2-17.

■ For instructions on how to place originals in

the RDF, see p. 2-18.

■ For instructions on how to place an original in

the SADF tray of the RDF, see p. 2-19.

Press the [FIT IMAGE] key.

The mode is selected, and the [FIT IMAGE] key

is highlighted.

MEMO:

● The preset Fit Image reduction ratio is 93%, but can

be changed as desired. (See “Additional Functions/

Fit Image Adjustments,” on p. 4-12.)

Proceed to copy.

(See “Making Copies,” on p. 2-4.)

MEMO:

● If shadows or lines from the original are reproduced

on copies then, set LOSE BIT OF IMAGE to ON.

(See “Fit Image Adjustments,” on p. 4-12.)

● To return to direct copying (100%), press the

[DIRECT] key.

● You can also return to direct copying by pressing

the

Reset

key. (The copier returns to the Standard

mode.)