Operator`s manual

2-46

Press the [ZOOM PROGRAM] key.

Enter the original size and the desired copy size

with the Number keys ([1] – [0]) in the display.

You can switch between the original size and

copy size settings by pressing the [ORIGINAL

SIZE] and [COPY SIZE] keys.

For example, to make a 3

/8" (80 mm) copy of a

/8" (150 mm) original, program the settings as

shown in the display on the right.

Press the [mm] key to enter in millimeters.

MEMO:

● When the copier calculates a copy ratio at less than

49%, it sets the copy ratio to 49%. When the copier

calculates a copy ratio at more than 204%, it sets

the copy ratio to 204%.

● Copy ratios are calculated as follows:

copy ratio (%) = (copy size ÷ original size) x 100

● If you enter an incorrect value, press the [C] key and

enter the value again.

● Using the Inch Entry under Additional Functions,

you can set the copier so that entry can only be

done in millimeters.

In this case the [INCH] key is not displayed.

● Enter [1] [–] [1] [/] [2] for 1-

/2".