Operator`s manual

2-51

Basic Copying

NOTICE:

● Be certain to place the original horizontally when copying LTRR, STMTR and other horizontal

sizes. If the original is placed vertically, the back of the copy will be copied upside down.

MEMO:

● If more than one one-sided original is placed in the RDF, the number of originals will be

automatically counted before copying begins. The Auto Count function can be canceled if you

specify whether you loaded an odd or even number of originals into the RDF.

• When you use the Auto Count function, the originals are fed through the RDF and

automatically counted before copying.

• If you specify the number of originals (EVEN NUMBER or ODD NUMBER), automatic

counting is not performed. Canceling automatic counting saves time and also reduces the

wear and tear on originals.

● If you use automatic counting when there are an odd number of originals, the back of the last

page is left blank. (The copier’s counter does not count a blank page as a copy.)

● The High Speed 1→2-sided mode, in which the Auto Count function is canceled, is only

available when you are:

• Using the RDF

• Making 1 or 2 sets of copies

• Using LTR-size originals (originals cannot be placed horizontally)

If you are copying an odd number of originals with copy paper that has right and left side

differences, to prevent copies from being output with the right and left sides reversed, you

should set the High Speed 1→2-sided mode to OFF. (See “Additional Functions/High Speed

1→2-sided,” on p.4-7.)

1 → 2-sided (Make Two-sided Copies from One-sided Originals)

This feature enables you to make two-sided copies from one-sided originals. The 1→2-sided

mode is set as the standard mode in this copier.

1→2-sided selected in the Two-sided mode

Originals

Copy

Place your originals.

■ For instructions on how to place an original on

the platen glass, see p. 2-17.

■ For instructions on how to place originals in

the RDF, see p. 2-18.

Press the [1→2-SIDE] key.