Easy Setup Instructions

Start Here
Easy Setup Instructions
Note
When moving the printer, carry the printer at both ends as shown below.
aPlacetheprinteronaatandhorizontalsurface,anddonot
placeanyobjectsinfrontoftheprinter.
PulluptheShippingtapeonthetopoftheprinter,andremoveittogetherwith
theProtectiveSheet.RemovealltherestoftheProtectiveSheets.
ThenopenthePaperSupport.
bOpen the Front Cover, then remove the Protective Material on
the right side.
Protective Material
Caution
Before turning on the printer, remove all of the shipping tapes.
cClose the Front Cover.
1 Prepare the Printer
dPlugthepowercordinthebackoftheprinterandconnectthe
otherendtothewalloutlet.
Power Cord
Note
DoNOTconnecttheUSBcableatthisstage.
ePress the POWERbuttontoturnontheprinter.Theprinterwill
initialize.Waituntilthe
POWERlampstopsashingandremains
lit green.
fOpentheFrontCover.TheFINECartridgeHolderautomatically
movestotheleft.
SerialNumber
g

Writedowntheserialnumberlocatedinsidetheprinter.Youwill
needthistoregisteryourproduct.
2 Install the FINE Cartridges
aRemovetheColorFINECartridgefromitsbox.
bRemovetheProtectiveTapegently.
To the FINE Cartridge Holder
Protective Tape
PrintHeadNozzles
Electrical Contacts
Note
DonottouchtheelectricalcontactsorPrintHeadNozzlesonaFINECartridge.The
printermaynotprintoutproperlyifyoutouchit.
DonotreattachtheProtectiveTapeonceyouhaveremovedit.
Becarefulnottostainyourhandsorsurroundingworkareawithinkontheremoved
Protective Tape.
c Insert the Color FINE Cartridge slightly slanted into the right slot
C
.
•
•
•
dPushuptheFINECartridgeuntilitclicksintoplace.
Important
For correct printer operation, make sure the FINE Cartridge is secure in slots.
Click
eRepeattheprocedurefortheBlackFINECartridge,insertingit
intotheleftslot
B
.
f Close the Front Cover.
Important
Once you have installed the FINE Cartridges, the POWER lamp will ash green.
Wait for about one to two minutes, until the POWER lamp stops ashing and
remains lit green and the printer has stopped making operating noises, before
proceeding.
Hardware setup is complete.
Photo Printer
Q T 5 0 9 1 8 V 0 1
Unpack the Printer
Pleaseconrmtheincludeditemsagainsttheillustrationprintedonthelidofthepackingbox.
AUSBcableisnecessarytoconnecttheprinterwithyourcomputer.
•
•