Printer User Manual

(3) Waste ink counter setting
When the logic board ass'y is replaced, reset the waste ink counter. In addition, according to the waste ink amount,
replace the waste ink absorber (ink absorber kit). The standard amount for waste ink absorber replacement is given
in the table below.
*1: Check the waste ink amount by service test print or EEPROM information print.
[See 3.3. Adjustment / Settings, (5) Service mode, for details.]
(4) User mode
<Standalone printer operation>
1) With the printer turned on, press the Menu button. Select Maintenance / Settings, proceed to Maintenance or
Device Settings, then select a desired operation.
Waste ink amount
*1
Ink absorber kit replacement
Less than 7% Not required.
7% or more Required.
Function Procedures Remarks
Print head manual cleaning - See "Standalone printer operation" below.
- Also available from the printer driver
Maintenance tab.
Print head deep cleaning - See "Standalone printer operation" below.
- Also available from the printer driver
Maintenance tab.
Paper feed roller cleaning See "Standalone printer operation" below.
Nozzle check pattern
printing
- See "Standalone printer operation" below.
- Also available from the printer driver
Maintenance tab.
Automatic / manual print
head alignment
- See "Standalone printer operation" below.
- Also available from the printer driver
Maintenance tab.
In Custom Settings of the printer
driver Maintenance tab, manual
print head alignment (by selecting
the optimum values) as with the
conventional models can be
performed.
Bottom plate cleaning
- See "Standalone printer operation" below.
- Also available from the printer driver
Maintenance tab.
Cleaning of the platen ribs
when the back side of paper
gets smeared.
Print head replacement The print head is replaceable at the
same position as for ink tank
replacement. (Open the access cover.
When the carriage stops at the center,
the print head can be replaced.)
Operation Remarks
Print head cleaning
Nozzle check pattern printing Set a sheet of plain paper (A4 or letter) in the ASF or the cassette
(according to the Feed Switch button setting).
Print head deep cleaning
Paper feed roller cleaning
Automatic / manual print head
alignment
Set a sheet of plain paper (A4 or letter) in the ASF.
1-24