PIXMA iP7200 Setup Guide © CANON INC.
Setup Guide This guide provides information for setting up a network connection for the printer.
Network Connection Wireless Connection a Preparation for Connection Before Starting Wireless Connection Setup 1. Make sure that the printer is turned on. If the power is on, the POWER lamp (A) will be lit. Notes on Wireless Connection • Make sure that the computer is connected to the access point (A) (or wireless network router) you want to connect your printer to. • The configuration, router functions, setup procedures and security settings of the network device vary depending on your system environment.
b Connection Using WPS 1. Press and hold the Wi-Fi button (A) on the printer when you are ready to press the button on the access point. 2. Make sure that the (blue) Wi-Fi lamp flashes quickly and the POWER lamp is lit as shown in the illustration above, then press and hold the button on the access point within 2 minutes. 3. Make sure that the (blue) Wi-Fi lamp and POWER lamp are lit. The network connection setup is now complete.
Troubleshooting WPS When the (blue) Wi-Fi lamp flashes slowly and the (orange) Alarm lamp is lit: • Press the button on only one access point. • Check the security settings of the access point. After checking the above points, wait for a while and configure wireless connection setting again. For details on how to check the security settings of the access point, refer to the manual supplied with the access point or contact its manufacturer.
