Service manual

Paper-pickup assembly
1. Remove the following assemblies:
●
Separation pad. See
Separation pad on page 66.
●
Scanner assembly. See
Scanner assembly on page 60.
●
Transfer roller. See
Transfer roller on page 73.
●
Right and left cover. See
Side covers on page 74.
●
Print-cartridge door. See
Print-cartridge door on page 76.
●
Rear cover and fuser cover. See
Rear cover and fuser cover on page 77.
●
Front cover. See
Front cover on page 79.
●
Formatter. See
Formatter on page 81.
●
Fuser. See
Fuser on page 96.
2. Release one tab (callout 1). Rotate the paper-pickup drive-shaft locking clip until the clip retainers
align with the holes in the chassis, and then remove the clip.
Figure 5-80 Remove the paper-pickup assembly (1 of 4)
1
100 Chapter 5 Removal and replacement ENWW