Service manual

3. Remove the drive-gear assembly.

CAUTION: Not all of the gears and springs are captive when you remove the drive-gear

assembly. Make sure that you do not lose any of the springs or gears when the assembly is

removed.

Figure 5-86 Remove the drive-gear assembly and drive belt (3 of 4).

4. Remove one gear (callout 4), and then carefully slip the drive belt (callout 5) off of the drive gear.

TIP: When you reinstall the main-motor drive belt, make sure that it is correctly positioned on top

of the spring-loaded tension idler and that it is not twisted (the grooves in the belt should face

inwards when the belt is correctly positioned).

Figure 5-87 Remove the Drive-gear assembly and drive belt (4 of 4).

104 Chapter 5 Removal and replacement ENWW