PIXMA MG3500 Setup Guide © CANON INC.
Setup Guide This guide provides information for setting up a network connection for the printer.
Network Connection Wireless Connection a Preparation for Connection Before Starting Wireless Connection Setup 1. Make sure that the printer is turned on. If the power is on, the (green) POWER lamp (A) will be lit. Notes on Wireless Connection • Make sure that the computer is connected to the access point (A) (or wireless network router) you want to connect your printer to. For details on how to check the settings, refer to the manual supplied with the router or contact its manufacturer.
b Connection Using WPS 1. Make sure that the button on the access point is ready to be pressed. 2. Hold down the Wi-Fi button (A) on the printer until the (orange) Alarm lamp (B) flashes once, then release the Wi-Fi button after the flash. 3. Make sure that the (blue) Wi-Fi lamp (C) flashes quickly and the (green) POWER lamp is lit as shown in the illustration on the right above, then press and hold the button on the access point within 2 minutes. 4.
Troubleshooting WPS When the (blue) Wi-Fi lamp flashes slowly and the (orange) Alarm lamp is lit: • Press the button on only one access point. • Check the security settings of the access point. After checking the above points, wait for a while and configure wireless connection setting again. For details on how to check the security settings of the access point, refer to the manual supplied with the access point or contact its manufacturer.
