Operation Manual

If
appears on the photo, the photos may be not scanned properly. Rescan the photo by
using left Function button.
Other options
Printing a Specified Area (Trimming)
7.
Confirm the print image, then use the
OK
button to go to the next step.
The print settings confirmation screen is displayed.
Note
You can also crop the print area again by using the center Function button.
8.
Use the
Color
button for color printing, or the
Black
button for black & white printing.
9.
Confirm the message, then set the printable disc.
Use the left Function button to see how to set the printable disc.
10.
Use the
OK
button to start printing.
The machine starts printing.
Note
Use the
Stop
button to cancel printing.
After printing, allow the printing surface of the disc to dry naturally. Do not use hairdryers or
expose the disc to direct sunlight to dry the ink. Do not touch the printing surface until the ink
has dried.
To keep the print quality at an optimal level, it is recommended to stop printing discs once
every ten discs when printing more than ten discs continuously.
To stop the printing operation, detach the Disc Tray from the printer, then close the Inner Cover.
After approximately three minutes have elapsed, open the Inner Cover, attach the Disc Tray to
the printer, then resume printing.
Page top
Page 457 of 1037 pagesReprinting Photo on the Disc Label