Setup Guide This guide provides information for setting up a network connection for the printer.
Wireless Connection a Preparation for Connection Before Starting Wireless Connection Setup 1. Make sure that the printer is turned on. If the power is on, the ON button (A) will be lit. Notes on Wireless Connection • Make sure that the computer is connected to the access point (A) (or wireless network router) you want to connect your printer to. • The configuration, router functions, setup procedures and security settings of the network device vary depending on your system environment.
4. Select LAN settings. 5. Press the OK button. 6. Select Wireless LAN setup. 7. Press the OK button. The (blue) Wi-Fi lamp (A) lights up when wireless connection is enabled. The printer will automatically search for access points supporting WPS (Wi-Fi Protected Setup).
d-A Push Button Method d Connection Using WPS 1. Press and hold the WPS button on the access point (for about 5 seconds). For details on pressing the WPS button, refer to the access point manual. 2. Press the OK button on the printer within 2 minutes. The (blue) Wi-Fi lamp on the printer flashes while searching for or connecting to the access point. 3. When the left screen appears, press the OK button. 4. Press the COPY button (A). The network connection setup is now complete.
d-B WPS d Connection Using WPS 1. Select WPS. 2. Press the OK button. 3. Select Push button method. 4. Press the OK button. 5. Press and hold the WPS button on the access point (for about 5 seconds). For details on pressing the WPS button, refer to the access point manual. 6. Press the OK button on the printer within 2 minutes. The (blue) Wi-Fi lamp on the printer flashes while searching for or connecting to the access point. 7. When the left screen appears, press the OK button. 8.
Troubleshooting WPS Multiple APs detected The screen appears when multiple access points are detected. Wait for a while, then configure WPS settings again. Press the WPS button on only one access point. Failed to connect The screen appears when an error occurs. Check the access point settings, then configure WPS settings again. For details on how to check the settings of the access point, refer to the manual supplied with the access point or contact its manufacturer.
