PowerShot SX520 HS Camera User Guide

73
Before Use
Basic Guide
Advanced Guide
1
Camera Basics
2
Auto Mode /
Hybrid Auto Mode
3
Other Shooting Modes
4
P Mode
6
Playback Mode
5
Tv, Av, and M Mode
7
Setting Menu
8
Accessories
9
Appendix
Index
Adjusting the Flash Output
Still Images Movies
Choose from the three ash levels in [ ] mode.
1
Enter [ ] mode.
● Set the mode dial to [ ].
2
Congure the setting.
● Raise the ash, press the [ ] button and
immediately turn the [ ] dial to choose
the ash level, and then press the [ ]
button.
● Once the setting is complete, [
] is
displayed.
● You can also set the ash level by accessing MENU (
=
27)
and choosing [
] tab > [Flash Settings] > [Flash Output].
● You can set the ash level in [
] or [ ] mode by accessing
MENU (
=
27) and choosing [ ] tab > [Flash Settings] >
[Flash Mode] > [Manual].
● You can also access the [Flash Settings] MENU screen (
=
27)
when the ash is up by pressing the [
] button and immediately
pressing the [
] button.
● After you set the shutter speed or aperture value, the exposure
level may change if you adjust the zoom or recompose the shot.
● Screen brightness may change depending on your specied
shutter speed or aperture value. However, screen brightness
remains the same when the ash is up and the mode is set to [
].
● To have the setting you did not congure in step 2 (whether
shutter speed or aperture value) automatically adjusted to obtain
standard exposure, hold the shutter button halfway and press the
[
] button. Note that standard exposure may not be possible with
some settings.
● With shutter speeds of 1.3 seconds or slower, ISO speed is [
]
and cannot be changed.
● [ ]: Manual
● Calculation of standard exposure is based on the specied
metering method (
=
59).