Operation Manual

95
Before Use
Basic Guide
Advanced Guide
Index
Camera Basics
Auto Mode /
Hybrid Auto Mode
Other Shooting Modes
P Mode
Tv, Av, and M Mode
Playback
Wireless Features
Setting Menu
Accessories
Appendix
4
Establish a connection with an
access point.
● Choose [Connect with WPS], and then
choose [WPS (PBC mode)].
● Press the WPS button on the access
point.
● Choose [Auto setting] on the camera’s
[IP address set.] screen to connect the
camera to the access point.
5
Enter your email address.
● Once the camera is connected to
CANON iMAGE GATEWAY, a screen is
displayed for entering an email address.
● Enter your email address and continue.
6
Enter a four-digit number.
● Enter a four-digit number of your choice
and continue.
● You will need this four-digit number later
when setting up linkage with CANON
iMAGE GATEWAY in step 8.
7
Check for the notication message.
● Once information has been sent to
CANON iMAGE GATEWAY, you will
receiveanoticationmessageatthe
email address entered in step 5.
● Press the
button on the next screen,
whichindicatesthatnoticationhas
been sent.
Registering CANON iMAGE GATEWAY
Link the camera and CANON iMAGE GATEWAY by adding CANON
iMAGE GATEWAY as a destination Web service on the camera.
Connect the devices near the access point, because you will need to
press the WPS button.
Note that you will need to enter an email address used on your computer
orsmartphonetoreceiveanoticationmessageforcompletinglinkage
settings.
1
Press the button.
2
Choose [ ].
3
Accept the agreement to enter an
email address.
● Read the agreement displayed and
choose [I Agree].