User Manual

Set to default
The set to default command applies the default properties to the selected page(s). Document
settings are not changed with this command.
1. Select the pages to which you want to apply the default settings.
2. Click [Pages] - [Set to default].
The following default properties are applied to the selected page(s):
Setting Set to When
Fold settings [None] • [Sheet fold] = [Z-fold]
• Document fold ([Multi half-fold],
[Gatefold], et cetera) and all pages
are selected.
[Hole punch] [None] All situations
[Force to front]
[Force to back]
[Force to none] All situations
[Mark pages] Off All situations
[Binding margin] 0 All situations
[Media] Default media based on the
page size of the selected
page(s)
All situations
[1-sided]
[2-sided]
[2-sided] All situations
[Staple] [None] • [Document type] = [Normal].
• [Document type] = [Multi half-fold]
and all pages in the output group
are selected.
[Document type] [Normal] All pages are selected
[Bleed tabs] [None] All pages are selected
Keep [Bleed tabs] Not all pages are selected
[Header and Footer] [None] All situations
[Stamps] [None] All situations
Set to default
134
Chapter 6 - The [Document] workspace
PRISMAprepare v7.1.1