User Manual

A variation is the [Simple gatefold]. One sheet folded in 8 panels. The left and right edges fold
inward with parallel folds and meet in the middle of the sheet without overlapping. Each side of a
sheet is a PDF page.
[Gatefold] and [Simple gatefold] are applied to all pages in the document.
Half-fold
In a [Half-fold] there is one sheet folded in 4 panels. The sheet is folded along a fold at the centre,
parallel to the short-edge of the page. Each side of a sheet is a PDF page.
A variation is the [Multi half-fold]. Multiple sheets are folded in 4 panels along a fold at the centre.
Each side of a sheet is a PDF page. The sheets are folded inside each other.
[Half-fold], [Long Fold] and [Multi half-fold] are applied to all pages in the document.
Page
This application presents the pages of a document to you. You can apply page program settings
to the pages of your document.
Page programmed
When you open a non-page programmed document in PRISMAprepare, then the application adds
page programming to the document. For example, a default media size is assigned and any PDF
bookmarks are converted into sections. Furthermore, the settings in the [Clean document
options] dialog are applied to the document. When you save the document, the document is
considered to be page programmed.
Panel
A panel is an area on a sheet which is delimited by:
• The edge of the sheet and a fold line.
• Two fold lines.
List of concepts
14
Chapter 1 - Introduction
PRISMAprepare v7.1.1