User Manual

Enable the JDF print path on the Fiery Print Server
Introduction
You have to enable the JDF print path on the Fiery Print Server and configure its paper catalog as
JDF based. Then, PRISMAprepare can send PDF files with a JDF ticket to the Fiery Print Server
using the JMF network protocol.
Now, PRISMAprepare can also download the media catalog from the printer. PRISMAprepare
compares the media used in the document with the media catalog from the printer. When
possible, the media in the document is mapped automatically to media from the printer catalog.
You have to map the media manually if the automatic media mapping is not correct or not
possible. See
Map the media manually in PRISMAprepare or on the Fiery Print Server on
page 156.
To solve any problems connecting to the Fiery Print Server, see
How to troubleshoot the
communication between PRISMAprepare and the Fiery Print Server on page 185.
Configure the Fiery Print Server
JDF settings
1. Connect to the Fiery Print Server and log in as administrator.
2. Click tab "Device Center", then click tab "General".
3. Click button "Server Configuration"
4. Click "Job Submission - JDF Settings".
5. Enable setting "Enable JDF". You can find this setting in the top of the dialog.
Disable setting "Override JDF job with the above settings".
6. Click "Save".
Paper catalog
1. Click tab "Job Center", then click "Paper Catalog".
Enable the JDF print path on the Fiery Print Server
180
Chapter 8 - Configure the Fiery Print Server
PRISMAprepare v7.1.1