User Manual

Clean-up scanned pages

You can clean-up scanned pages. Click the [Clean-up] button to have these operations available.

• Rasterize a page.

• Rotate the scanned page content.

• Remove all speckles.

• Put scanned content straight on a page.

• Align the scanned content.

• Erase areas of the scanned content.

Fold lines and punches are not displayed in the [Clean-up] [Preview] view.

Question: Some pages are not recognized as scanned pages. How can I clean-up these pages?

Answer: You have to rasterize pages which are not recognized as scanned pages. You can clean-

up the rasterized pages.

NOTE

Any mask that you apply on page content disappears when you click the [Clean-up] button. After

you close the [Clean-up] dialog, the mask appears again. For example, you have masked some

page content. Then you click the [Clean-up] button. This causes the mask to disappear. In the

[Clean-up] dialog you align the content of the page. Then you close the [Clean-up] dialog and the

mask appears again. Now, the mask might cover some of the aligned page content. Therefore,

always do a clean-up before you mask any content.

Rotate the scanned page content

1. Select the scanned pages that you want to clean up. Click [Select] - [Scanned pages] to select

all scanned and rasterized pages.

• To select a page range: select a page in the structure view, press the <Shift> key, then

select another page.

• To select non-sequential pages: select a page in the structure view, press the <Ctrl> key,

then select several non-sequential pages.

2. Click [Pages] - [Clean-up].

• If required, rasterize the pages that are not recognized as scanned pages.

3. Click the [Rotate 180°] tab.

4. Select the scanned pages for which you want to rotate the page content.

5. Click [Apply].

The page content of the scanned pages is rotated 180 degrees.

Clean-up scanned pages

Chapter 4 - The [Pages] workspace

PRISMAprepare v7.1.1