Specifications

– 29 –
6.2 Settings for Printing and Transfer (Page: 2/3)
6.2.2 Items
PRINT Whether to print the result
“
ON”: Results are printed with the internal printer of the R-F10.
“
OFF”: Not printed.
[FMT] Results of refractometry to be printed out.
Regardless of whether “STD” or “AUTO” is selected, data for “MEM”
will be printed when PRINT switch is pressed for more than 2 sec-
onds, or when measurements vary widely and the reliability of any
one of the measurements is low when “AUTO PRINT” is “ON”.
“STD”: Standard values
“MEM”: 10 newest measurements and a standard value for each
eye in memory
“AUTO”: In case of small dispersion of the data, the standard value
is printed. Otherwise, the standard value and all data are
printed.
[MSG] Whether to print the messages entered in section 6.3
“ON”: Messages are printed.
“OFF”: Not printed.
[EYE] Whether to print a sketch of eyeball and refraction diagram according
to the results of refractometry
“ON”: A sketch of eyeball and refraction diagram are printed.
“OFF”: Not printed.
[ECO] Reduction of printout
“ON”: The size of printout will be reduced.
“OFF”: Non-reduction
[How to change the setting]
Press either START switch or PRINT switch.
TRANS Whether to transfer the measurement data to external instrument or
not
NOTE: Please contact Canon representative or distributor when
connecting external instrument to the R-F10.
“ON”: Data is output in RS232C interface. Data that can be output
are: results of refractometry, pupil distance and measure-
ment date.
“OFF”: For no transfer.