User Manual

REALiS WUX10 Mark II D 11/1/09
Architect & Engineer Specification
www.usa.canon.com/projectors
(800) OK-CANON
Bid Spec
1.0 Description
The projector shall be WUXGA resolution. It should use LCOS technology with high contrast and
high brightness. Projector shall have seamless image with high uniformity. It must include power
zoom and power focus. Lens should be wide angle - 100 inch diagonal screen at less than 10 feet.
2.0 Bid Specification
Technology:
a. The projector must use the LCOS technology and incorporate AISYS system.
b. The projector must have a native resolution of WUXGA (1920 x 1200).
c. The projector must support WXGA (for wide screen use).
d. The projector’s brightness must be 3200 lumens with contrast of 1000:1.
e. The projector lens must have a wide angle lens (100 inch diagonal screen at less than 10 feet).
f. The projector must have a built in powered optical zoom lens of 1.5 times.
g. The projector’s pixel aperture must be 90% or higher.
h. The projector’s uniformity must be 85% or higher.
Image Adjustments:
a. The projector must have a DICOM Simulation mode.
b. The projector must have 21 steps of preset gamma adjustment.
c. The projector must have a Photo mode.
d. The projector must have color temperature adjustment.
e. The projector must have color level adjustment.
f. The projector must have sRGB color space.
g. The projector must have automatic keystone correction of ±20 degrees vertically.
h. The projector must have the ability to be placed in a vertical position with the lens pointing up or down.
AC Lamp:
a. The projector must have an AC Lamp to improve optical efficiency for better color reproduction and brightness.
User Friendly Features:
b. The projector must have auto input detection.
c. The projector must have auto focus.
d. The projector must have auto vertical keystone.
e. The projector must have auto wall color correction.
f. The projector must have an internal charging unit to run the fan for an adequate period of time, in order for the
lamp to cool down when power has been accidentally removed from projector.
Inputs and Outputs:
a. The projector must have one HDMI™ (V.1.3 with Deep Color).
b. The projector must have one DVI input.
c. The projector must have one VGA output to drive external monitor or other display device.
d. The projector must have three audio input sources that switch automatically to match the image signal’s input
source.
e. The projector must have a variable audio output terminal for connection to external audio devices making it easy
to control sound levels from the projector’s remote control unit.
f. The projector must have component input.
g. The projector must have composite video input.
h. The projector must have a RS-232 port for control.
i. The projector must have a built-in network interface for control
Power Management:
a. The projector must have an internal condenser to run the fan making it possible to unplug the projector as soon
as it is turned off, to prevent damage to the projector and lamp in case of accidental power lost.