Instruction manual

Troubleshooting Guide
If there is a problem, refer to this Troubleshooting Guide
The Speedlite does not fire.
+ The batteries are installed in the wrong orientation.
Bb Install the batteries in the correct orientation. (p.8)
a The Speedlite's internal batteries are exhausted.
If the flash recycling time takes
30 sec. or longer, replace the
batteries. (p.8)
e The Speedlite is not attached securely to the camera.
Bb Attach the Speedlite's mounting foot securely to the camera. (p.9)
e The electrical contacts of the Speedlite and camera are dirty.
bl
b Clean the contacts.
The slave unit does not fire.
e The channel does not match the master unit's channel.
b Set it to the same channel as the master unit. (p.29)
a, The slave unit(s) is not positioned properly.
b Place the slave unit within the master unit's transmission range.
(p.26)
h Point the slave unit(s)'s sensor toward the master unit. (p.26) I
The power turns off by itself.
r, Auto power off took effect.
tar Press the shutter button halfway or press the <PILOT> button.
(p.10)
The entire LCD panel blinks.
(J The wide panel has been pulled out for bounce flash.
b Retract the wide panel. (p.18)
Auto zoom does not work.
b The Speedlite is not attached securely to the camera.
b. Attach the Speedlite's mounting foot securely to the camera. (p.9)
COPY