EL-100 Advanced User Guide
46
Fully Automatic Wireless Flash Photography
Setting up receivers
3
Set an optical channel.
z
Set the channel switch to the same
channel as set on the sender.
z
Firing is not possible unless the
sender and receiver channels match.
4
Set the ash group.
z
Set the Mode dial to <
4
>.
5
Position the camera and the ash.
(p.42)
If there is a uorescent light or computer monitor near a receiver unit, the
presence of the light source may cause the receiver unit to malfunction and
re inadvertently.
o
To re the sender ash as well, activate sender ring in step 5 (p.16).
o
Press the camera’s depth-of-eld preview button to re the modeling
ash (p.23).
o
You can change the time until the receiver unit’s auto power o takes
eect (C.Fn-10, p.40).