Operation Manual
Table Of Contents
- Contents
- Chapter 1 Welcome !
- Chapter 2 Setting Up
- Chapter 3 Getting Started
- Chapter 4 Setting Up and Using Speed Dialing
- Chapter 5 Using the Fax as a Copier
- Chapter 6 Sending Documents
- Chapter 7 Receiving Documents
- Chapter 8 Using the Memory Features
- Chapter 9 Using a Relay Network
- Chapter 10 Using Confidential Mailboxes
- Chapter 11 Setting Up and Using Polling
- Chapter 12 Other Special Features
- Chapter 13 Restricting Use of the Fax
- Chapter 14 Printing Reports and Lists
- Chapter 15 Maintenance & Frequently Asked Questions
- Chapter 16 Summary of Important Settings
- Appendix A Specifications
- Appendix B Documents You Can Scan
- Glossary
- Index
15-34 Maintenance & Frequently Asked Questions Chapter 15
LASER CLASS 3170 Series.
CFYA/YAH/YAN 120v US V1.0
3.
Locate the stamp pad then apply only one drop of ink to the
stamp ink compartment.
❏ To avoid a malfunction, do not add too much ink.
❏ Use only Shachihata X Stamper Ink CS-20 Yellow.
❏ Do not use the stamp feature for at least one hour. If you have
to send a document, turn off the stamp feature for the first
hour. (➞12-10)
TO AVOID INK SPILLAGE, APPLY ONLY ONE DROP OF INK TO
THE STAMP PAD.
4.
Follow steps 10 to 12 on pages 15-32 and 15-33 to close the ADF
cover, lower the document feeder tray, and connect the power cord
of the fax unit to the power source.
• Make sure that you do not drip ink on any other part of the fax.
• Make sure that you put the plastic loop back in place when you close
the ADF cover. (➞15-33)