Operation Manual
Table Of Contents
- Contents
- Chapter 1 Welcome !
- Chapter 2 Setting Up
- Chapter 3 Getting Started
- Chapter 4 Setting Up and Using Speed Dialing
- Chapter 5 Using the Fax as a Copier
- Chapter 6 Sending Documents
- Chapter 7 Receiving Documents
- Chapter 8 Using the Memory Features
- Chapter 9 Using a Relay Network
- Chapter 10 Using Confidential Mailboxes
- Chapter 11 Setting Up and Using Polling
- Chapter 12 Other Special Features
- Chapter 13 Restricting Use of the Fax
- Chapter 14 Printing Reports and Lists
- Chapter 15 Maintenance & Frequently Asked Questions
- Chapter 16 Summary of Important Settings
- Appendix A Specifications
- Appendix B Documents You Can Scan
- Glossary
- Index
iv Preface
LASER CLASS 3170 Series.
CFYA/YAH/YAN 120v US V1.0
CONNECTION OF THE EQUIPMENT
This equipment complies with Part 68 of the FCC rules. On the rear
panel of this equipment is a label that contains, among other informa-
tion, the FCC Registration Number and Ringer Equivalence Number
(REN) for this equipment. If requested, this information must be given
to the telephone company. This equipment may not be used on coin
service provided by the telephone company. Connection to party lines is
subject to state tariffs.
The REN is used to determine the quantity of devices which may be
connected to the telephone line. Excessive REN’s on the telephone line
may result in the devices not ringing in response to an incoming call. In
most, but all areas, the sum of the REN’s should not exceed five(5.0). To
be certain of the number of devices that may be connected to the line, as
determined by the total REN’s contact the telephone company to deter-
mine the maximum REN for the calling area.
An FCC compliant telephone cord and modular plug is provided with
this equipment. This equipment is designed to be connected to the
telephone network or premises wiring using a compatible modular jack
which is Part 68 compliant.
(Note: RENs are associated with loop-start and ground-start ports. Do
not use for E&M or digital ports.)
Even if the dual-line option is installed, the REN is applicable to each
port.
This equipment if it uses an optional telephone receiver is hearing aid
compatible.
IN CASE OF EQUIPMENT MALFUNCTION
Should any malfunction occur which cannot be corrected by the proce-
dures described in this User’s Guide, disconnect the equipment from the
telephone line and unplug the power cord. The telephone line should
not be reconnected or the switch turned on until the problem is com-
pletely resolved. Users should contact their local authorized Canon
Facsimile Service Dealer for servicing of equipment.