Operation Manual
Table Of Contents
- Contents
- Chapter 1 Welcome !
- Chapter 2 Setting Up
- Chapter 3 Getting Started
- Chapter 4 Setting Up and Using Speed Dialing
- Chapter 5 Using the Fax as a Copier
- Chapter 6 Sending Documents
- Chapter 7 Receiving Documents
- Chapter 8 Using the Memory Features
- Chapter 9 Using a Relay Network
- Chapter 10 Using Confidential Mailboxes
- Chapter 11 Setting Up and Using Polling
- Chapter 12 Other Special Features
- Chapter 13 Restricting Use of the Fax
- Chapter 14 Printing Reports and Lists
- Chapter 15 Maintenance & Frequently Asked Questions
- Chapter 16 Summary of Important Settings
- Appendix A Specifications
- Appendix B Documents You Can Scan
- Glossary
- Index
2-24 Setting Up Chapter 2
LASER CLASS 3170 Series.
CFYA/YAH/YAN 120v US V1.0
Save the protective bag and all other shipping material. You will need
this material later when you dispose of the cartridge after it has run out
of toner. (➞15-18)
3.
Hold the cartridge by the ends and rock it gently five or six times
to distribute the toner evenly inside the cartridge.
4.
Place the new cartridge on a stable, flat, clean surface, and snap
the tab to detach it from the cartridge.
5.
As you steady the cartridge with one hand, remove the seal by
gently pulling the plastic tab with your other hand. Use a firm,
even pull to avoid breaking the seal.
• Do not pull the tab upwards or downwards; the tape may break.
• If the tab breaks off from the tape, pull the tape out by pulling on the
end of the tape where the tab was originally attached.
•Wash off any toner from your hands or clothing immediately with cold
water.
PULL STRAIGHT OUT