Specifications

7.2 Settings for Printing and Transfer (Page: 2/3)
– 37 –
NOTE: Regardless of the setting, data in memory will be printed/
transferred if the PRINT switch is pressed more than two
seconds.
[MSG] Whether to print the messages entered in section 7.3 with the result
“
ON”: Message is printed.
“
OFF”: Message is not printed.
[ECO] Whether to reduce the size of the printout
“
ON”: Size of printout will be reduced.
“
OFF”: Non-reduction
[How to change the setting]
Press either START switch or PRINT switch.
TRANS Whether to transfer the measurement data to external instrument or
not
NOTE: Please contact Canon representative or distributor when
connecting external instrument to the TX-F.
“
ON”: Data is output in RS232C interface.
“
OFF”: For no transfer.
[FMT] Transfer format
NOTE: For details concerning format, please contact Canon repre-
sentative or distributor.
[How to change the setting]
Press either START switch or PRINT switch.
[BAU] RS232C data transfer speed and data format
9600.8N1
9600: Transfer speed “
300/600/1200/2400/4800/9600/
19200
”
8: Transfer bit “
7/8”
N: Parity “
E/O/N”
1: Stop bit “
1/2”
[How to change the setting]
(1) Turn the roller or press FIXATION switch or LIMITER switch to
select transfer speed or transfer format.
(2) Press either
START switch or PRINT switch to change the set-
ting.