Instruction manual

This allows you to move quickly through still pictures recorded anywhere on a

tape (photo search) or between different days or areas of recording (date search).

• You can only use this function from the wireless controller.

1. Press down and slide the POWER switch to VCR.

2. Press the SEARCH SELECT button to choose between photo/date

search.

• PHOTO SEARCH or DATE SEARCH is shown in the display for a few

seconds.

3. Press the - and + buttons to move backwards or forwards

through the still pictures or between different days of recording.

• Press once to move to the start of the previous/next still picture or day on

the tape.

• You can press more than once to move to the corresponding still picture or

day (up to a maximum of 10 times), e.g. press the + button 5 times to

move forward 5 still pictures or days.

• PHOTO SEARCH/DATE SEARCH appears in the middle of the display

alongside the - or + mark and number search through. The recording

mode is also shown (SP/LP).

Using the Full

Range of Features

OFF

VCR

POWER

SELECT

Searching the Tape (Photo Search/Date Search)

Notes:

• Press 3 (stop) to end your search.

• If you begin a search very close to the start of a recorded still picture during

photo search, the camera may skip straight past it.

• When you have set the area for the World Clock, date search also looks for the

change in date based on the adjusted time.

• A date/area cannot be identified if the total recording time on that day/area was

less than one minute.

• Date search playback may start just before or after the beginning of the located

section.

• If the data code is not displayed correctly you will not be able to operate the

date search correctly.