Instruction manual

Using the Full

Range of Features

Returning to a Pre-Marked Position

Use the wireless controller to go back to a pre-determined point on a tape

following playback.

1. Press the ZERO SET MEMORY button during playback at a point

you want to return to later.

• The time code is replaced by a tape counter that is set to zero with the

indication.

2. When you have finished playback, fast forward or rewind the tape.

The tape stops automatically when it reaches the zero set position.

• The tape counter with indication disappears from the display and the time

code reappears.

Notes:

• Press the ZERO SET MEMORY button once more to cancel the zero set

memory before you forward/rewind the tape.

• The zero set memory may not function correctly where there is a break between

recordings on the tape.

• You can also use zero set memory to mark a position on a tape in record pause

mode. When you then play back the tape, pressing rewind will take you back to

the pre-marked position.

• If you remove the tape while the zero set memory is set, the memory is canceled

and the tape counter reverts to timecode.

OFF

VCR

POWER

REW

PLAY

REC

PAUSE

SELECT

ZERO SET

MEMORY

STOP

PAUSE

SLOW