Operation guide Decurler Unit-C1
Copyright and Trademarks Copyright Copyright 2016 Océ. Illustrations and specifications do not necessarily apply to products and services offered in each local market. No part of this publication may be reproduced, copied, adapted or transmitted, transcribed, stored in a retrieval system, or translated into any language or computer language in any form or by any means, electronic, mechanical, optical, chemical, manual, or otherwise, without the prior written permission of Océ.
Contents Contents Chapter 1 Preface................................................................................................................................. 5 Notes for the reader......................................................................................................................................... 6 Naming Conventions for Accessories (Generic Naming in User Interfaces).............................................. 8 Chapter 2 Use the decurler......................................
Contents 4 Canon Decurler Unit-C1
Chapter 1 Preface
Notes for the reader Notes for the reader Typography This manual uses the following typography to indicate elements that are part of the user interface.
Notes for the reader Symbol Type of symbol Indicates IMPORTANT Indicates operational requirements and restrictions. Be sure to read these items carefully to operate the machine correctly and to avoid damaging the machine or property. NOTE Indicates a clarification of an operation or contains additional explanations for a procedure. Reading these notes is highly recommended.
Naming Conventions for Accessories (Generic Naming in User Interfaces) Naming Conventions for Accessories (Generic Naming in User Interfaces) Generic Naming of Accessories in User Interfaces To improve the readability of texts in User Interfaces of control panels and software, the accessories are generally referred to by their function. The table below shows the naming conventions for accessories (commercial product names and the generic terminology used in User Interfaces).
Chapter 2 Use the decurler
Correct Curled Media via the Control Panel Correct Curled Media via the Control Panel Introduction This procedure describes how to correct curled media via the control panel. Make test prints on the adjusted media to check the curl. IMPORTANT You are advised to make small increments to avoid paper jams. NOTE You can also correct curled media via the Settings Editor. NOTE If the curl correction values are different for LEF and SEF, you must create two media in the media catalog.
Correct Curled Media via the Control Panel 3. Touch [Optimize] -> [Curl correction]. 4. Define the correction. When the media curls upward, adjust downward (+). When the media curls downward, adjust upward (-). NOTE When you print a 1-sided job face up, select [Output face up]. When you print a 1-sided job face down, select [Output face down]. When you print a 2-sided job, select [2-sided output]. 5. Touch [OK].
Correct Curled Media via the Settings Editor Correct Curled Media via the Settings Editor Introduction This procedure describes how to correct curled media via the Settings Editor. Make test prints on the adjusted media to check the curl. IMPORTANT You are advised to make small increments to avoid paper jams. NOTE You can also correct curled media via the control panel. NOTE If the curl correction values are different for LEF and SEF, you must create two media in the media catalog.
Chapter 3 Troubleshooting
Labels inside the Decurler Labels inside the Decurler Introduction If a paper jam occurs in the decurler, the control panel will display the location of the paper jam and a procedure to clear the paper jam. Follow the procedure on the control panel to clear the paper jam. The procedure contains references to the error locations you must check, for example A2 or A3. The illustration below shows an overview of all the error locations.
Clear a Paper Jam in the Decurler Clear a Paper Jam in the Decurler Introduction When a paper jam occurs in the decurler, the control panel will display the location of the paper jam and a procedure to clear the paper jam. Follow the procedure on the control panel to clear the paper jam. The procedure below describes how to clear a paper jam in the decurler. CAUTION • When you remove jammed originals or paper, take care not to cut your hands on the edges of the originals or paper.
Clear a Paper Jam in the Decurler Step Action Illustration 3 Remove any jammed paper. 4 Close the guide (X-A). CAUTION When you close the guide, be careful not to get your fingers caught, as this may result in personal injury. 5 Close the front door of the decurler. CAUTION When you close the front door, be careful not to get your fin‐ gers caught, as this may result in personal injury. 6 16 Follow the instructions on the control panel.
Chapter 4 Specifications
Specifications Specifications Decurler Unit-C1 18 Item Specification Description Fixes paper curl caused by heat etc. Supported media sizes • Maximum: 320.2 mm x 487.7 mm (13" x 19.2") • Minimum: 140 mm x 182 mm (5.5" x 7.2") Supported media weights 50 - 300 g/m² (14 lb bond - 110 lb cover) Dimensions (HxWxD) 1,040 mm x 250 mm x 792 mm (40.9" x 9.8" x 31.2") Weight 48 kg (105.8 lb) Power source The power is supplied via the print engine.
Index Index A Accessories Commercial naming.......................................... 8 Generic naming..................................................8 C Components Commercial names............................................ 8 Conversion table for commercial names and user interface names........................................................ 8 Curled media Control panel.................................................... 10 Settings Editor..................................................
Index 20 Canon Decurler Unit-C1
CANON INC. 30-2, Shimomaruko 3-chome, Ohta-ku, Tokyo 146-8501, Japan CANON U.S.A., INC. One Canon Park, Melville, NY 11747, U.S.A. CANON CANADA INC. 8000 Mississauga Road Brampton, ON L6Y 5Z7, Canada CANON EUROPA N.V. Bovenkerkerweg 59, 1185 XB Amstelveen, The Netherlands CANON AUSTRALIA PTY. LTD Building A, The Park Estate, 5 Talavera Road, Macquarie Park, NSW 2113, Australia CANON CHINA CO., LTD 2F Jinbao Building No.89 Jinbao Street, Dongcheng District, Beijing 100005, China CANON SINGAPORE PTE.
