VB-C300 Start Guide Manual

2-6
Connect the Camera to the Network and Perform the Initial Setting
The network connection is now complete.
 When using external power supply
When using external power supply, use the Power
Connector (→ P.vi) supplied with the camera.
Connect the cables as shown to the right when using
the supplied Power Connector.
Supply 12VDC or 24VAC from a power supply
insulated from 100-240VAC supply. You can connect
12VDC power supply without regard to the polarity.
Recommended power supply cables for VB-C300 [for reference]
Cable (AWG) #24 #22 #20 #18 #16
Conductor diameter (0.52mm) (0.65mm) (0.82mm) (1.03mm) (1.30mm)
(ømm) (0.020inch) (0.026inch) (0.032inch) (0.041inch) (0.052inch)
12VDC
Maximum cable length (m) 591423 32
Maximum cable length (ft) 16.4 29.5 45.9 75.5 104.9
24VAC
Maximum cable length (m) 11 18 29 46 64
Maximum cable length (ft) 36.1 59.1 95.1 150.9 210.0
Voltage range for power supply 12VDC: 10.8V - 13.2V
24VAC: 22.8V - 25.2V
Use a UL cable (equivalent to UL-1015) as the power cable for 12VDC or 24VAC.
Note
● The camera head position is automatically initialized when the power supply is
turned ON.
● Never touch the camera head while its position is being initialized. If you touch it,
the head position may not be initialized correctly, or other malfunctions may result.
● Wait at least 5 seconds before turning the power back on after shutting it off. Turning
it on too quickly may result in a malfunction. Observe the precautions given in
“Safe Use of Equipment/IMPORTANT SAFETY INSTRUCTIONS (→ P.viii, x), “Safe
Use of Equipment/When using the camera with PoE HUB (→ P.xiii) when plugging
and unplugging the power cable.
● Read the manual of the PoE HUB for how to power it ON or OFF.
● You can connect the AC adapter (optional) to the camera while it is powered from the
PoE HUB. In this case, the PoE-supplied power is used while it is active, and the
power from the AC adapter (optional) is not used. When the PoE-supplied power is
disconnected, the power supply automatically switches to the AC adapter (optional).
Stripping length
approx. 4mm - 6mm
(0.16inch - 0.24inch)
Screwdriver
Power
Connector
(Supplied)