VB-C300 Start Guide Manual

2-9
Installing the Camera
4. A setup progress window appears and
your settings will be saved.
Note
● Set the IP address to a value that suits your environment.
● Where the IP address has been automatically obtained from the DHCP server, you
cannot change the IP address setting from the VB Initial Setup Tool. Change the IP
address from the Network Settings page (→ dOperation Guide P.1-7).
● Please consult with your network administrator for the IP address, subnet mask
and default gateway address settings.
● If 20 minutes or more have passed since the VB-C300 was turned on, the VB-
C300 stops sending requests for IP addresses allocation and they cannot be
detected using the VB Initial Setup Tool. In this case, turn the camera OFF then
ON again.
● To restore the factory default settings, refer to “Restoring the Factory Default
Settings” in the Operation Guide (→ dOperation Guide P.4-8).
Connect the Camera to the Network and Perform the Initial Setting
5. Click “OK”.
Initial settings are now complete.