VB-C300 Start Guide Manual

2-20
2. Determine the mounting position of the camera.
Aligning with the camera orientation, determine the screw hole locations for the Backside
Ceiling Bracket and the hole location for the In-Ceiling Bracket, then mark them with a pencil.
(Mounting dimensions)
• Screw hole diameter: 6.5mm (0.26inch) across
3. Drill three mounting screw holes for the Backside Ceiling Bracket and a hole
for the In-Ceiling Bracket on the ceiling.
Note
After drilling the holes, clean the mounting location so that drilled refuse may not
enter the inside of the dome when installing the Indoor Dome Housing.
4. Mount the Backside Ceiling Bracket on the back side of the ceiling.
Tip
It is recommended to temporarily secure the Backside Ceiling Bracket with a two-
sided tape to the ceiling, so that it may not get loose when the dome is mounted on
the ceiling.
Insert the female parts on the Backside Ceiling Bracket into the holes drilled in step 3.
Setting Up the Camera