VB-C300 Start Guide

2-20
2. Determine the mounting position of the camera.
Aligning with the camera orientation, determine the hole locations for the Backside Ceiling
Bracket and the hole location for the In-Ceiling Bracket, by using the template for the dome
housing then mark them with a pencil.
3. Drill three mounting holes for the Backside Ceiling Bracket and a hole for the
In-Ceiling Bracket on the ceiling.
Note
After drilling the holes, clean the mounting location so that drilled refuse may not
enter the inside of the dome when installing the Indoor Dome Housing.
4. Mount the Backside Ceiling Bracket on the back side of the ceiling.
Tip
It is recommended to temporarily secure the Backside Ceiling Bracket with a two-
sided tape to the ceiling, so that it may not get loose when the dome is mounted on
the ceiling.
Insert the convey parts on the Backside Ceiling Bracket into the holes drilled in step 3.
Setting Up the Camera
Dome Template Backside Ceiling Bracket
ø
7.0mm
Hight
10.0mm