Operation Manual

2-17

Step 4 Install the Camera

Initial Setting and Installation of Camera

2. Remove the dome case.

 VB-C500VD

Loosen the three dome case lock screws using the bundled dome case lock screw wrench.

 VB-C500D

Loosen the two dome case lock screws on the side face of the camera. Loosen the screws

until they are sticking out.

3. To connect various interface cables (audio, I/O, power), remove the cable cover at the bottom

of the camera.

* The figure shows VB-C500D.

Note

When removing the dome case, be careful not to scratch or dirty the dome.

Dome case lock screw

C500VD

C500D

Dome case lock screw

Dome case lock screw wrench