User Guide

2-7
Setting Up
Turning the Power ON and OFF
The VB-C50FSi/VB-C50Fi itself does not have a power switch. You can switch the VB-C50FSi/
VB-C50Fi on by plugging the AC adapter into a wall outlet. The LED flashes when the VB-C50FSi/
VB-C50Fi is communicating. When the power supply is turned ON, the LED momentarily flashes.
Note
● Wait at least 5 seconds before turning the power back on after shutting it off. Turning
it on too quickly may result in a malfunction. Observe the precautions given in “a
Safe Use of Equipment/a IMPORTANT SAFETY INSTRUCTIONS” (→ P.xii).
● If the picture and audio recording* function is being used, shutting off the
power or restarting the VB-C50FSi/VB-C50Fi will delete all the pictures and
audio*.
* Only available with a particular model of the VB-C50FSi (→ P.iii)
● For information on turning the PoE hub on and off, refer to the user's manual supplied
with the hub.
● When power is supplied to the VB-C50FSi from a PoE hub, the AC adapter can
also be connected to the camera. In this configuration, because the PoE hub power
supply takes priority when power is supplied from the hub, the AC adapter power is
not used. If the PoE supply is cut, the power supply is automatically switched to the
AC adapter.
The network connection is now complete.
AC cable
to AC outlet
AC adapter
Main unit
PoE hub
LAN cable
VB-C50FSi
When power is supplied to the VB-C50FSi via a LAN cable using a PoE hub, connecting the LAN
cable to a hub that is being supplied with power will turn the VB-C50FSi on.
2. Connect the Camera to the Network