User Manual
Table Of Contents
- Introduction
- Contents
- How to Read This Document
- Top Page of the Camera
- Chapter 1 Detailed Settings
- Setting Menu
- Accessing the Setting Menu
- Setting the Administrator Password, LAN, IPv6, DNS, etc. (Network)
- Setting the Date and Time (Date and Time)
- Setting the Camera Control and External Device Name (Camera)
- Setting the Image Size, Quality and Frame Rate (Video)
- Setting HTTP/FTP Upload and E-mail Notification (Upload)
- Setting the Image Server, Audio Server and HTTP Server (Server)
- Setting the Image Buffer, Motion Detection, Audio Playback and Interval Timer (Event)
- Setting User Access Privileges (Access Control)
- IPsec Settings (IPsec)
- Setting the Items Requiring Rebooting (Reboot Item)
- Viewing Event Logs and Current Settings, and Performing Maintenance (Maintenance)
- Chapter 2 VBAdmin Tools
- Chapter 3 VB-C60 Viewer
- Chapter 4 Creating Web Pages for Video Distribution
- Chapter 5 Appendix
![](/manual/canon/vb-c60/user-manual-english/images/img-25.png)
1-9
Setting the Administrator Password, LAN, IPv6, DNS, etc. (Network)
1
1
Detailed Settings
IPv6
(1) [IPv6]
Select [Disable] or [Enable] regarding the use of IPv6.
(2) [IPv6 Address]
If [Enable] is selected for IPv6, an automatically acquired address will be shown.
Note
z For [IP Address], [Subnet Mask] and [Default Gateway Address], contact your network
administrator.
z If any of the [IP Address], [Subnet Mask] and [Default Gateway Address] settings is wrong,
network access may be disabled. In this case, use VB Initial Setting Tool ("Perform Initial
Setting of the Camera" in Start Guide) to set the address again.
z If the [IP Address], [Subnet Mask], [Default Gateway Address], [LAN Interface] or
[Maximum Packet Size] setting is changed, the camera may become no longer accessible
from the active browser. Check beforehand the precautions explained in "Notes" in "Setting
the Items Requiring Rebooting (Reboot Item)" ( P. 1-49). Also check the precautions in the
same section before changing each setting in "[IPv6]" ( P. 1-9) and "DNS" ( P. 1-10).
z If [Auto (DHCP)] is selected as the address setting mode, the IP address may not be
assigned correctly in certain environments, such as when a router is present between the
DHCP server and this camera. In this case, assign a fixed IP address by selecting
[Manual].
z If you are using IPv6, set 1280 or greater value under [Maximum Packet Size].
Tip
z If you are using optical fiber or ADSL, you may be able to improve the sending efficiency by
slightly reducing the maximum packet size.
z You can use the VB Initial Setting Tool to check the IP address assigned by [Auto (DHCP)].
Tip
In an environment where IPv6 cannot be used, the [IPv6 Address] field remains blank even
when [Used] is selected for IPv6.