Operation Manual

28
To use a camera, it is necessary to first set the
administrator password for the camera, then configure the
network settings, and then connect the camera and
computer via the network. Use the Camera Management
Tool to configure these settings.
The Camera Management Tool also enables multiple
cameras to be configured at the same time.
As cameras are assigned IP addresses (192.168.100.1) in
their factory desfault state, their initial settings can also be
configured via a web browser.
Flow of Configuration Using the Camera
Management Tool
Launching the Camera Management Tool

Searching for Cameras
Search for cameras connected to the same network as
the computer in which the Camera Management Tool is
installed.

Registering the Administrator Password

Configuring Initial Camera Settings
Configure the basic settings of the camera, such as the
network settings and camera name.
For information on how to use the Camera Management
Tool, please refer to the “Camera Management Tool User
Manual”.
Accessing from the Web Browser
The [Default Settings] page will be displayed.
After the camera reboots, the top page is displayed
and you can configure the settings.
Making Initial Camera Settings
1
Launch the web browser.
2
Enter 192.168.100.1, and press the Enter key.
3
Enter the administrator password, and click [Apply].