User manual

132
(1) [Sequence Name]
Enter the name of layout sequence.
(2) [Type]
Specify the type of layout sequence.
(3) [Available Layouts]
Displays a list of available layouts.
(4) [Add Layout]
Add the selected layout to the [Sequence Layouts] list.
(5) [Move Up] and [Move Down]
Move the selected layout up or down in the list to change the sequence order.
(6) [Remove Layout]
Remove a layout from the list.
(7) [Sequence Layouts]
Displays a list of layouts in the order of the layout sequence.
You can set the display time for each layout in [Interval (sec)].
(8) [Interval]
When a layout is added to a sequence, the set display time will be added here. The display time can be
changed after being added to [Sequence Layouts]. Specify from 5 to 9999 (sec.).
Resume Layout Sequence
In the following situations, the layout sequence automatically stops.
• When you click the layout area
• When you obtain camera control privileges
• When you click [Grids] on the toolbar and select a grid type from the displayed menu
• When you open a menu on the menu bar
• When you switch to another tab or open a new tab
• When a layout property is canceled, e.g., because it was deleted by a Viewer on another computer
When stopped, “Paused” appears in the title bar as shown below.
To resume a stopped layout sequence, click [Layouts] menu > [Resume Layout Sequence].
During full screen display, right-click anywhere in the viewing area outside the video windows and click [Resume
Layout Sequence], or press Ctrl+R to resume the sequence.
3
Click [OK] to close the dialog box.