User manual

ManualsBrandsCanon ManualsSecurity Video SolutionsCanon VB-H630D

Setting a Recording Schedule

Note

• If you select [MPEG-4] or [H.264] for the [Video Format] setting, the [Maximum Frame Rate] setting cannot be changed. The

settings on the camera are used for recording.

• It may not be possible to record at the specified frame rate depending on the load on the Storage Server CPU or the hard disk.

Recording may also pause intermittently.

• Recording may be performed at lower than the specified frame rate, depending on the number of Viewers that are accessing the

camera, the load on the camera and Storage Server, variation in network traffic, and the environment at the time of recording.

• Audio recording is enabled when the recording mode is selected. You cannot schedule audio-only recording.

• If MPEG-4 or H.264 recording format is used, the recorded audio will not be in sync with the recorded video. If JPEG recording

format is used, the recorded audio will be in sync with the recorded video for the most part, however it is not guaranteed that it will

be completely in sync.

• Recording mode stream operates only with cameras that support the recording mode stream function and if a stream has been

acquired.

• To use recording mode stream, select [Video Format] > [JPEG] or [Digital PTZ (JPEG)], and set [Maximum Frame Rate] to “10” or

less.

• When the recording-mode stream function is used, the streamed video has a higher priority than the live video. Depending on the

load on the camera, such as the number of Viewers that are simultaneously connected to the camera, display of the live video

may stop.

If an upload function is already being used on the camera, you cannot use the recording-mode stream function. To use the

recording-mode stream function, select [Upload] > [Upload Disabled] on the Setting Page of the camera.

[Digital PTZ (JPEG)] cannot be selected for [Video Format].

• Only supports [JPEG] for the [Video Format].

• The maximum frame rate is five fps.

 Sensor Recording Settings

(1) [Do not record]

Select to not record even when there is a signal from this sensor.

You can individually enable or disable recording for each sensor. For example, you may not want to record

when there is door sensor signal, but to start recording when there is a window sensor signal.

(2) [Start Recording]

H45

M44

H730MkII

S30MkII

S31MkII

S80xMkII

S90xMkII

S30

S31

S80x S90x H43

H41

H630

H610

H730

H710 M42 M40

M620

M600

720

M700

C500

C60

H45 M44

S30MkII

S31MkII

M50

H761

H760

64/25/9

(3)

(1)

(2)

(4)